APPLICATION GUIDELINES:
- TEST A SMALL AREA to determine cleanina results.
- Pre-wet pavers with fresh water.
- Apply cleaner with low-pressure plastic sprayer.
- Use a stiff bristle nylon brush or broom to remove severe stains.
- Rinse surface thoroughly with power washer.
- Can be diluted with up to 5 parts of water.
- DO NOT ALLOW CLEANER TO DRY ON THE SURFACE.
- Clean new pavers before installing the sand joints.
- Use the lowest water pressure possible when cleaning pavers when the sand joints are already installed.
- Recommended dwell times may be higher or lower based on the pavers porosity and the severity of the stains.
LIMITATIONS:
- Do not mix bleach or other cleaners.
- Multiple cleanings may be necessary for severe build-up.
- Do not use in temperatures below 32F or above 90F.
- Not effective as a paint stripper.
- Use caution near colored concrete and grout.
- Failure to thoroughly rinse the pavers may cause surface discoloration.
COVERAGE:
- Clay/Concrete Pavers: 400 - 500 sq. ft./gal
- Stone Pavers: 300 - 400 sq. ft./gal
IMPORTANT: Read product container before starting project.