APPLICATION TECHNIQUES:
- SPRAYER: Pass nozzle about 8 to 12 inches from the surface in straight, short swipes. Allow the first coat to dry for 15 minutes. A second coat may be applied to achieve higher sheen.
- IMPORTANT : This product dries quickly when sprayed. To remove any surface imperfections, dampen a 1/4" roller with Lacquer Thinner. Slowly roll the area and repeat if needed.
APPLICATION GUIDELINES:
- Apply one coat of product to a small, inconspicuous area. If the product does not penetrate or produces results in any way which are not satisfactory to you, discontinue its use and contact a Lifeguard Customer Service representative. Wait a least 24 hours to determine compatibility.
- Avoid application on DIRTY or WET surfaces. Do not apply to previously painted, sealed or stained surfaces. Protect freshly coated surfaces from dust, rain and traffic white drying.
- Power Washing with at least 2000 psi is recommended. General cleaning can be done by using Lifeguard Paver Cleaner & Brightener in conjunction with a power-washer. For stains and efflorescence use Lifeguard Rust or Efflorescence Remover. Read product container for specific instructions and cautions.
- Allow at least 48 hours of drying time after power washing.
- Be sure to mask off glass, plastic and metal. Protect plants, grass and other materials by shielding or covering.
- The joint sand needs to be level with the bottom of the chamfer on beveled pavers. The sand must be 1/8" below the surface on non-beveled or tumbled pavers.
DRYING TIME:
- Allow at least 12 hours for foot traffic.
- 24 hours for water exposure.
- 72 hours for vehicle traffic.
CLEAN UP:
- Cleans up easily with Lacquer Thinner.
- Equipment must be thoroughly cleaned after use.
IMPORTANT: Read product container before starting project.