APPLICATION GUIDELINES:
- Mix thoroughly, use an electric drill mixer prior to application.
- Always apply to test area and wait at least 24 hours to determine compatibility.
- The surface should not be shiny or tacky.
- Apply a heavy coat. Allow product to penetrate for a few seconds and back roll.
SURFACE PREPARATION:
- Power-Washing with at least 2000 psi. General cleaning can be done by using Lifeguard Concrete & Masonry Cleaner. For rust stains or efflorescence, use Lifeguard Rust Stain Remover or Lifeguard Efflorescence Remover.
- Read product container for specific instructions and cautions.
LIMITATIONS:
- Do not apply if the surface temperature is above 90°F
- Do not apply to stucco with a 20/30 sand finish.
- Do not apply paint over Lifeguard
DRYING TIME:
- Allow 24 hours for foot traffic.
- Lifeguard takes 48 hours to set up and initial water barrier.
- Allow 96 hours for vehicle traffic.
CLEAN UP:
- Clean equipment with mineral spirits or paint thinner.
- If excess product remains on the surface one-hour or more, use toluene on cloth and rub gently to remove.
COVERAGE RATES:
- Estimated coverage: 50-200 sq.ft/gal.
IMPORTANT: Read product container before starting project.